Vinyl Fencing in Bend, Oregon

Vinyl is the fence for people who want to put it in and stop thinking about it. It doesn't rot, it doesn't splinter, and it never needs a coat of stain, which matters in a place where the high desert sun can gray out a cedar fence in a couple of summers. A white or tan vinyl fence looks the same in year ten as it did the week it went in, as long as it was built right. That last part is the catch. Vinyl panels are only as straight as the posts holding them, and Central Oregon's freeze and thaw is hard on posts that weren't set deep enough. We install vinyl fences across Bend, Redmond, and Sunriver, with every post set in concrete below the frost line and the layout checked before we dig.

Below we cover where vinyl makes the most sense, how it holds up to our winters and sun, how an install goes, and how we fix vinyl when something breaks. If you're still deciding between materials, our fence installation page compares cedar, metal, and vinyl side by side. Quotes are free and come in writing.

Prefer to write it out? Get a free quote

When Vinyl Is the Right Choice

Vinyl makes the most sense when low upkeep matters more than anything else. Busy families, rental owners, and second-home owners who only get to Central Oregon a few weeks a year tend to love it, because there's no staining schedule to keep up with. It works well around pools and hot tubs, since water doesn't hurt it, and it's easy to hose clean if the dust kicks up. It comes in full privacy panels, semi-privacy styles with small gaps, picket fences for front yards, and two- or three-rail designs for larger lots. The tradeoffs are worth knowing too. Vinyl costs more up front than a basic cedar fence, the color is set at the factory and can't be changed later, and some HOAs don't allow it, so we always check your HOA rules before quoting.

How Vinyl Holds Up to Bend Weather

Good vinyl is made with UV inhibitors, and that matters at 3,600 feet, where the sun is strong year round. Cheaper vinyl can yellow or turn chalky, so we only install products made for outdoor sun. Cold is the other thing to plan for. Vinyl gets stiffer in hard cold, and a panel that would flex in July can crack in January if something hits it, like a snowblower, a thrown chunk of ice, or a kid's sled. Snow piled high against a privacy fence also pushes on it the way wind does. Posts set deep and solid in concrete handle all of this far better than shallow ones, and gate posts get a metal insert inside the vinyl so they don't flex under the weight of the gate.

How We Install a Vinyl Fence

First we visit, measure, and talk through style, height, and gates. Bend allows up to 3.5 feet in the front setback and 6 feet along side and rear setbacks, which is why most vinyl privacy fences go in at 6 feet. We'll ask whether you've had a recent survey, since the fence should sit on your side of the property line, and we call in a utility locate before any digging. Posts go in first, set plumb in concrete and spaced to fit the panels exactly, because vinyl doesn't forgive a post that's off by an inch. Once the concrete cures, rails and panels slide into place and caps go on top. Most residential vinyl fences are done in two to four days, and we haul away the old fence if there is one.

Vinyl Fence Repair

Vinyl is tough, but it's not unbreakable. The calls we get most are cracked panels or rails from an impact in the cold, sections pushed over by wind when a post shifts, and gates that sag because the gate post wasn't reinforced. The good news is that vinyl is built in pieces, so a broken panel or rail can usually be swapped out without touching the rest of the fence. If a post has moved, we reset it in fresh concrete and put the section back in line. Matching color is the one tricky part, since older vinyl can fade slightly, so we'll tell you up front if a new piece might look a shade brighter than its neighbors. For leaning posts or storm damage on other fence types, see our fence repair page.

Want a gate that matches your new vinyl fence? We build and fix gates of every size, from walk-through gates to double drive gates.